Common faults of electric lock
2023-05-04
1. If the electric control lock stops running due to a lack of power during use, first check the battery of the electric control lock to see if it needs to be replaced. After replacing it with a new battery, if it still cannot be used normally, it may be a problem with the circuit. At this time, it is necessary to inspect and repair the circuit of the electric control lock. 2. If the electronic lock is said to have expired or the time on the electronic lock is incorrect, resulting in the inability to open the door, a new door card needs to be replaced to try and see if it can be used normally. 3. If the red light on the system identification of the electronic control lock is incorrect and accompanied by four short beeps, it may be an error in the system identification. Replace the system card. 4. If the door lock cannot be opened when using a legitimate card to open the door, the alarm green light will light up, and there will be a short"drip" sound. At this time, the battery may have malfunctioned and needs to be replaced. 5. When the electric control lock is mechanically unlocked, the yellow light will light up. At this time, the door cannot be opened. You can use the intelligent emergency card to try to open the door. If it does not work, you need to find relevant personnel to handle it. 6. The yellow light comes on when the Electric Lock is reversed. And accompanied by two short sounds of "drip", which makes it impossible to open the door. You can cancel the lock card and unlock it, so that the door can be opened
Mr. ksj